Technical Tip: How to disable the logs of web-filt...

fortega · 02-24-2025

Description This article describes how install a new user into a group of VPN IPsec dial-up setup from FortiManager. Scope FortiManager, FortiGate. Solution In a standard configuration of VPN IPsec dial-up users are not referenced in Firewall policie...

fortega · 01-05-2018

DescriptionWhen trying to connect via the GUI to the FortiGate VM it is possible to receive the following message and the GUI cannot be accessed.This will occur if the FortiGate VM cannot connect to the FortiGuard servers to register the license.Scop...

fortega · 12-04-2017

Description This article describes how to see the number of free IPs of an internal DHCP server on a FortiGate. Solution When FortiGate assigns an IP to a host from the internal DHCP server it generates an informational log with the ID: 0100026003, T...

fortega · 07-03-2017

Description This article describes how to configure a FortiSwitch port to allow Jumbo Frames. Scope This configuration is useful for all the FortiSwitchs. Solution Into the CLI run the following commands: # config switch physical-port edit port1 set ...

fortega · 03-28-2017

Description This article describes how to disable the management from FortiCloud to FortiGate. Scope This configuration applies to FortiGate v5.2.x and above. Solution FortiCloud version 3.1.0 onwards includes the beta service of management, this fea...

User Statistics

User Activity

Technical Tip: How to push a new user for a VPN IPsec Dial-up setup from FortiManager

Technical Note: Unable to access FortiGate VM via GUI

Technical Tip: How to see the number free IPs allocated by the internal DHCP server

Technical Tip: Configure Jumbo Frame in FortiSwitch

Technical Tip: How to disable management from FortiCloud

Technical Tip: How to disable the logs of web-filt...

KCS

Fortinet Training Institute

User Statistics

User Activity

You are leaving our website