Description This article describes how to troubleshoot traffic issues
after configuring Policy Route for Internet traffic. Scope FortiGate.
Solution The Policy Route is needed to steer Internet traffic from the
usual outgoing Internet line: config ro...
Description This article describes NP Modules on FortiGate virtual
appliances. Scope FortiGate VM. Solution Network Processor is a hardware
acceleration module that is used to offload high volume network traffic.
As the name implies, it is only avail...
Description This article describes about issue when internal web traffic
uses port 8008. Scope FortiGate. Solution There may be cases wherein the
user's internal web server is using port 8008. Accessing the server from
the same subnet is working. But...
Description This article describes the empty FortiView Sessions
dashboard after upgrading to v7.4.5. Scope FortiGate 7000F Series.
FortiOS version 7.4.5. Solution By accessing the management IP address
of the FortiGate Chassis, it will be connected t...
Description This article describes how to troubleshoot if the firewall
policy is not showing byte counts after the FortiOS upgrade. Scope
FortiGate-7000F Series v7.4.5. Solution After an upgrade to v7.4.5, the
firewall policy shows 0-byte counts on t...
The numbers on datasheet was done on lab environment and those are only
a benchmark of what the hardware could possibly handle. But I believe
only Fortigate product team know exactly how the test was done. For any
capacity planning enquiries, I would...
you can create VLAN interface (tagged interface) under that one physical
interface
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-create-a-VLAN-tagged-interface-802-1q-on-a/ta-p/193893
after that you can specify the default route,wh...
few articles you can read up about it :
https://community.fortinet.com/t5/Support-Forum/why-do-we-assign-secondary-IP-address/m-p/219857
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Set-a-secondary-IP-on-a-FortiGate-interface/ta-p/226046
Based on the available command you shared, I don't think it's possible.
Once the ports are member of LACP interface, most likely that older
version can't refer to the physical port anymore.
It's a bit tricky to set management access on FGT Transparent Mode. You
may want to check docs send by Minh for more detailed deployment.
Usually when you have multiple VLAN going through FGT, you need to
define forward domain. So the traffic will no...
