Description This article describes the functionality of interface-policy
on FortiGate. Scope FortiGate. Solution Consider an interface-policy
configured on FortiGate as follows: config firewall interface-policy
edit 1 set uuid b7c08d6c-1491-51f0-a0a2...
Description This article describes why an eBGP peer may not change the
next hop to itself due to the BGP NEXT_HOP attribute. Scope FortiGate.
Solution An eBGP router always uses its own IP address as the next hop
address when advertising a route. Con...
Description This describes hardware acceleration support with respect to
802.1 Q-in-Q VLAN tags. Scope FortiGate. Solution Consider the following
VLAN interfaces configured on FortiGate-I. config system interface edit
"vlan111" set vdom "root" set ip...
Description This article describes the option to enable/disable
auto-generated VLANs that are dynamically created upon first switch
discovery on the FortiLink interface. Scope FortiGate, FortiOS 7.6.3
(and later). Solution As of FortiOS version 7.6.3...
Description This article describes the behavior of the default gateway
setting under IPsec tunnel configuration on FortiGate. Scope FortiGate.
Solution Consider a dialup IPsec VPN tunnel configured on FortiGate as
follows: config vpn ipsec phase1-int...
hi @ganesh_karale , It sounds like an unexpected behavior. Please open a
ticket with Fortinet TAC and share the configuration along with the
screenshot of the error for further investigation.
Hi @aguerriero, Please disable offloading on firewall policy and see if
the issue persists. If possible, please upgrade to FortiOS 7.4 version
as well as it could be something specific on 7.2.
Hi @RolandBaumgaertner72 , well it totally depends how you would prefer
to have the setup. Without SD-WAN, you can modify the distance/priority
settings as explained in the below link.
https://community.fortinet.com/t5/FortiGate/Technical-Note-Routin...
Hi @RolandBaumgaertner72 Thank you for reaching out the Fortinet
community. If you prefer one WAN link over another, you can configure
SD-WAN rules to prioritize traffic. SD-WAN rules are checked from top to
bottom (first match).
https://docs.fortine...
