hi, today I set up email alerts for various events (so, event based and
not severity level based), and I am missing a setting for hardware
failure events, you know, fans, PSU, temperature. A look into the CLI
didn't help.Am I thinking too hard, and t...
Hello fellows, for simplicity, I often use my private SSH key to log in
into my local admin account on various FGTs (I mean, CLI access via
SSH). Now, if instead of a local admin account I use a wildcard admin
account against LDAP/MS AD in the backgr...
hello all, I've got a pair of FG-200B running v4.3.18 in A-P HA mode.
Each cluster member is at a different location, HA links are across a
dedicated line. On each site, there is one Cisco access router (19xx) in
front of the FGT providing WAN access...
hello all, I'm planning to place the slave unit of a Fortigate HA
cluster into a remote location. There is a leased line (layer 2) for the
HA connect. Can anybody confirm that I can run the HA traffic across a
VLAN between the access switches on each...
oops, sorry that was a misunderstanding.LZ4 compressor/decompressor is
readily available here on Github or in a 7-zip version here I haven't
seen the lz4_reader tool on the FTNT support site but I think it's not
FTNT specific.
I am truly confused...where to start?You create VLANs in Network -
Interfaces, Create, VLAN. You _have_ to enter an IP address, like
10.20.30.1/24. The .1 becomes the VLAN's gateway, the /24 determines
it's size.Always enable Ping on any interface yo...
I might be way off but '.tar.gz' is a very common compression format.
IIRC even WinZip or 7zip can decompress/unzip it. It might be that on
the first run you'll get a .tar file (which is in cleartext anyway) but
you can unpack that in a second run.
My guess is that the FGT silently drops traffic to/from the secondary IP
because it doesn't know where to route it.Primary addresses always get a
"connected" static route immediately.Secondary addresses? Have a look at
Dashboard - Network - Routing. ...
