Description This article describes that one time, the STP root port flap
was seen on a non-root bridge FortiSwitch after the STP root Bridge
FortiSwitch rebooted. Scope FortiSwitch 1xx series, v7.4.x. Solution
Consider the setup below: FortiSwitch1 i...
Description This article describes how FortiSwitch behaves when multiple
RADIUS servers are configured. Scope FortiSwitch 7.x and above. Solution
For configuration steps for RADIUS Authentication on FortiSwitch, see
Troubleshooting Tip: Configure and...
Description This article describes the process and behavior of managed
FortiSwitches when the FortiLink management VLAN is changed from the
default VLAN 4094 to a customized VLAN. Scope Managed FortiSwitches and
FortiGate version 7.2.x and above. Sol...
Description This article describes how to verify from the FortiAP
whether the FortiGate WiFi Controller 1+1 fast failover is functioning
correctly. Scope FortiAP, FortiGate v7.2.x and above. Solution Refer 1+1
fast failover configuration using the be...
Description This article describes how to validate if the 'reset-button
disable' functionality is working or not. Scope FortiSwitch versions
7.2.7, 7.4.3, 7.6.0 and above. Solution Refer to the following document:
Using the Reset button on FortiSwitc...
Hi Kurt, I am assuming that you have given IP of 10.100.99.2 to the
FortiSwitch's internal interface and not the SVI. In that case, when we
connect 10.100.99.2 to FGT X2 interface 10.100.99.1, the traffic will
flow as untagged vlan. Usually this shou...
Thats correct, p2p is not possible in this design. p2p means
FGT-FSW-cisco-FSW.https://docs.fortinet.com/document/fortiswitch/7.6.1/fortilink-guide/801183/fortilink-over-a-point-to-point-layer-2-network
Fortilink over layer3 is the correct approach.
I tested in FSW version 7.4.4 against FortiGuest and it works fine. Have
you tried configuring from FSW CLI? It could be a GUI issue where
'remote' option shows greyed out. Try upgrading FSW to the latest 7.4.6.
my config FYI:- config system adminedi...
