Just ordered our first 40F and I'm just looking through the supported
versions... It seems I have a choice of 6.0.6 or 6.4.0 and that's pretty
much it. No other releases seem to have firmware for the 40F, not the
later 6.0.x's or any 6.2.x or the mos...
Basically there are 3 different series. FortiAP - Can be managed by
FortiGate or by FortiCloud; Cannot be managed by WLC FortiAP-U - This is
the universal series, can be managed by FortiGate, FortiCloud, or WLC
Legacy Meru or 822/832 - Only managed b...
But isn't that remote-id from the other end's perspective? Specify the
local-id on the fortigate to match? remote-id does not match with
remote-id Fortigate | NSXLocal ID - Match with other side remote |
Remote ID - match with other side localRemote ...
To my knowledge it will effectively rely on IPs as it's ID in ike2/ike1
main mode, local-ID is configurable while remote is not in ike2/ike1
main. Which I've never seen be a problem personally unless we are
getting into double NAT scenarios. Personal...
I think a lot of what I said doesn't even apply to your scenario,
apologies for that. The scenario is a fortigate on the same subnet as a
NAS acting as AD. I hope I am correct this time. I would simply change
the DHCP scope to give out the NAS IP as ...
You will need to setup source IPs for those functions so the fortigate
knows what IP to send from. In the case of LDAP:config user ldapedit
'your ldap name'set source-ip 'your internal IP'end This is because the
fortigate uses the interface it exits ...
