Re: FortiSIEM Collector Upgrade Issue

Goutham_FTNT · 06-13-2019

Goutham_FTNT · 05-10-2016

Description This article describes the steps to allow a specific YouTube content video and block all other content from YouTube. Scope All FortiGate units. Solution Enable 'Inspect All Ports' under SSL/SSH inspection – Deep inspection. Navigate to Po...

Goutham_FTNT · 09-21-2015

Description This article describes the steps to configure FortiGate's OID as a custom sensor on PRTG Network Monitor. Scope Any supported version of FortiGate. Solution GUI configuration Log in to the FortiGate device.To enable SNMP on the Interface:...

Goutham_FTNT · 06-15-2015

Description This article explains how to reset the packet count option for a firewall policy. Solution GUIa) In FortiOS v5.01) Right click on the value of Count field on the firewall policy under Policy > Policy > Policy.2) Select "Clear Counters" fr...

Goutham_FTNT · 04-16-2024

Hi @adem_netsys I didn't get any logs to check however I was suspecting the 7za issue on the collector From your collector please install this package - yum install p7zipThen try the install again from the GUIIf that's not helping - I would suggest s...

Goutham_FTNT · 03-19-2024

Hi @Gerkhan We require complete logs to see the upgrade flow As the upgrade happens in 90 seconds it just goes for restart I suspect the image or unzip issues - Do you have a ticket for this ? I think it's best to be on session and fix this . If yes,...

Goutham_FTNT · 03-08-2024

Hi @adem_netsys Strange that it stopped without any changes on the server or clientHere is the command which you can run from collector (if the pull is via collector) or super to get the complete error :runJdbcProbe.sh jdbcType hostIP hostPort dbName...

Goutham_FTNT · 03-08-2024

When you click on Install image - If the upgrade task takes less time that is withint 5 mins - It shows as task finsihed then you need to check the md5sum on the collector /opt/upgrade/FSMxxxx.zip - match this checksum from support site and also form...

Goutham_FTNT · 03-06-2024

Hi , So his was working fine and stopped to work all of a sudden ?Any upgrade done recently on SIEM ?Version on the SIEM ?Also any changed done on the server side ?

User Statistics

User Activity

Re Dashboard | Perf Status | Avg EPS , Event Rate EPS , Std Dev EPS

Technical Tip: Allowing a specific YouTube video whilst blocking all other YouTube content

Technical Tip: SNMP v3 connecting to PRTG and adding a custom sensor on PRTG SNMP tool using a FortiGate OID

Technical Note: How to Reset Count on the Firewall Policy