Troubleshooting Tip: Using the FortiOS built-in pa...

pkungatti_FTNT · 09-08-2021

Description This article describes how to add the source Mail ID for the Automation trigger and Alert Mail.The requirement of adding the source Mail ID is some of the mail servers will not accept the mail if the source Mail ID is not properly set.For...

pkungatti_FTNT · 01-26-2021

DescriptionThe link control protocol (LCP) frames are transmitted during the link establishment and termination phases, and periodically during the life of the link. It is used to negotiate the configuration of the PPP link, and to test and maintain ...

pkungatti_FTNT · 11-27-2020

Description This article describes how to configure SOCKS (Socket Secure) in explicit proxy.Solution Execute the below commands to configure socks in explicit proxy: # config web-proxy explicit set socks enable / disable et socks-incoming port useren...

pkungatti_FTNT · 10-14-2020

DescriptionThis article describes the implementation of shortest path first scheduling and throttling in FortiOS.SolutionOverview.- When an OSPF router receives an updated LSA, it does not run SPF right away but schedules it. It does so in case there...

pkungatti_FTNT · 10-29-2019

DescriptionThis article explains the Routing Change and Session Fail-over with SD-WANSolutionLet us consider the three Interfaces port 1, 2 and 3 are configured over an SD-WAN interface and participating in a Performance SLA. If the Failure Threshold...

pkungatti_FTNT · 11-22-2021

Dear JonasYour issue required to verify configuration and do deeper troubleshooting. I would suggest to raise a ticket with Fortinet technical support. Visit us at https://community.fortinet.com to get answers to questions, technical documentation, a...

User Statistics

User Activity

Technical Tip: How to set Source Mail for Automation Trigger and Alert Mail

Technical Tip: How to modify the LCP Echo timer in L2TP VPN

Technical Tip: Configure SOCKS in explicit Web proxy

Technical Tip: How to Implement OSPF SPF scheduling and throttling

Technical Note: Routing Change and Session Fail-over with SD-WAN

Re: L3 VLAN interface up, but IP/Network missing under locally connected network

Troubleshooting Tip: Using the FortiOS built-in pa...

Technical Note: Routing Change and Session Fail-ov...

Fortinet Training Institute

KCS