Hello, I have noticed that in FMG 7.0, when trying to add a static route
to the SD-WAN interface, I'm getting an error message "router/static/3/
: device can not be empty". As a result, I cannot add a static route to
SD-WAN via the FMG. Has something...
Hello, In the standalone Fortiswitch, we can configure the following
VLAN settings in a port: Native VLAN, Allowed VLAN list and Untagged
VLAN list. This configuration is available only in the standalone
switch; when the switch is managed by a FortiG...
Hello, I'm trying a dialup IPsec VPN with mode config in 7.0 with
FortiClient (7.0 also) and it seems that the client is not provisioned
with an IP address. The debug shows that a connection is been
established at phase 1, but after a few P1 retransm...
Hello, Is it recommended using a FortiLink as monitored interface for a
cluster? If no, why? I have seen a best practice about monitor interface
selection, but there is no mention to FortiLink. An easy guess would be
that a FortiLink interface would ...
This reminds me of the 90s, where the cabling installers used to split
the UTP cable and terminated the wire pairs in two plugs. One was used
for data and the other was for telephone. This way they saved money, by
using less cable. Back then, the Eth...
Hi, This is probably due to a bug and Fortinet has distributed the
following information to partners: Access to Websites blocked using SSL
inspection -Bug ID 750551 There appears to be an ongoing issue with the
certificate chain of a root certificate...
Thanks a lot for the answer Ken. Makes sense. To comment on your last
statement, in order to answer to myself if I need that feature or not, I
need to understand why it is there for :) So far, it seems that using
the native VLAN is enough.
I have seen this document. But it's not clear to me the difference
between the native vlan and the untagged vlan. Can you tell me a use
case where the untagged-vlan list is needed?
Ι'm suggesting you to try with FortiPoC. You'll need an account to
Fortinet Developer Network and you have to contact a Fortinet SE to
provide you with the FortiPoC image. Cheers
