Hello,I am experiencing an issue with the dot1x configuration on
FortiNAC.I am using FortiNAC 700F, version 7.2.8.0149. I have followed
all the steps shown in this
video:https://www.youtube.com/watch?v=7pRg2-SVipoThe problem is that I
don’t have the ...
Hello Fortinet Community,I'm currently facing an issue with my
FortiNAC-F 7.2.8 (previously 7.2.7, upgraded in an attempt to resolve
this) when trying to connect to switches via the Validate Credentials
button in the device configuration. The credent...
Hi everyone,I'm setting up a FortiSIEM Supervisor All-in-one (AIO) with
version 7.2.0, but I've encountered an issue with the Collector.When I
go to Admin → Setup → Collector, there is no option to configure the
Collector’s IP or designate the server...
Hello everyone,I am encountering issues with setting up multicast
traffic in a Layer 2 environment. Although the PCs can ping each other
and are correctly connected to the Wi-Fi network, the VLC client is
unable to receive the multicast stream sent b...
Hello everyone, I’m back with another issue related to FortiNAC... In
the client's network infrastructure where FortiNAC is deployed, there is
an Explicit Proxy configured on the FortiGate.If I disable the proxy on
the test machine, the FortiNAC Capt...
User and domain information masked. fortinac # execute tcpdump -i any
host 172.27.1.98 and port 1645 -vtcpdump: data link type
LINUX_SLL2dropped privs to admintcpdump: listening on any, link-type
LINUX_SLL2 (Linux cooked v2), snapshot length 262144
b...
user@domain.com was added afterward to mask the user's information; the
original logging contained the user's details correctly.Testing from
enter-shell using wbinfo with user credentials in the format DOMAIN\user
works properly.On the FortiNAC side,...
After further investigations (by enabling debug radius):Dec 5
13:28:16.246: dot1x-ev:[Gi1/0/1] Interface state changed to UPDec 5
13:28:16.571: dot1x-packet:[d45d.646c.d656, Gi1/0/1] queuing an EAPOL
pkt on Auth QDec 5 13:28:16.571: dot1x-packet:EAPO...
Furthermore, in the reference video mentioned in the first post, at
minute 14:01, I see that the switch should send RADIUS information with
attributes such as User-Name [1], Service-Type [6], cisco-nas-port [2],
etc.When I run show logging, I don’t s...
