I have a pair of fortiswitches configured with mc-lag icl. im running
into an issue when i attempt to create a trunk. I want to use port 21 on
switch 1 and port 21 on switch 2 but i am not able to select them . they
do not show in the list? what is p...
Hello I'm new to fortiswitch . Do i need to use dedicated ports for
fortilink traffic? Should these ports be 1G or 10G? How much bandwidth
is required? If I understand correctly fortilink traffic is different
(seperate) than my normal data traffic so...
hello i have 2 switches maged by fortilink i have created a layer 2
port-channel (lacp) to my cisco switch . i would like to enable layer 3
on this port-channel how do i configure an ip address on the fortinet
side?do i use the cli of the fortigate o...
i have a created a new trunk group on the fortiswitcchmc-lag enabled,
STP Enable , Edge portlacp active port 48,port48CiscoLACP mode
activePort channel 13Cisco switch is running MST spanning tree mode
(same as fortiswitch) when i try to enable to por...
ok but when you say the recommendation a tiered approach you are saying
that the switches should be dual-homed as well? what's the difference
between a ring topology and an access switch with only a single uplink
correct me if i am wrong but my understanding that in a tiered topology
and for my access layer specifically - I would need to dual home every
single access switch? Correct?
it's up now. so one side is passive and the cisco side is active is the
recommended approach? I always thought they should match on both side. i
disable edge port for mc-lag - is this required because I am spanning
across a 2 FSW.
