basically, 2 factory default 1500D units, basic management interface config applied and working. vdom support enabled but nothing other than that defined on the boxes.
Trying to cluster them in an active-standby pair and im seeing that the master and the slave recognize each other as cluster members (get system ha status), cluster status is OK, but the slave is showing not-synced. However, the issue looks like its a bit more basic than an out of sync config.
Also, on the primary GUI, if I select system, HA, only the primary box appears but if I select 'show HA stats' in the top right corner, both units are shown but the slave unit is all zero counters and although the serial number is there, the hostname isn't. So looks like some level of basic comms isn't happening
Looking a bit deeper, the reason seems to be that they are not passing sync traffic to each other, even though they have learned about each other over the same ha cables ( 2 x point to point cables, direct, no switch inbetween, both up/up).
a debug seems to show that they are trying to sync but both are failing to communicate using the built in IP addresses, and reporting the following.....
<WARN> ............ connect(169.x.x.x) failed: 113(no route to host)
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.