- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i have FortiSwitch-124F-FPOE v7.4.0,build0767,230602 (GA) and i cant config netflow or sflow
i have FortiSwitch-124F-FPOE v7.4.0,build0767,230602 (GA) and i cant config netflow or sflow,
I just can configure these commands
config system sflow
config collectors
edit "172.16.220.20"
set ip 172.16.220.20
next
end
end
is netflow or sflow needs licenses ???
how can
- Labels:
-
Fortiswitch
-
FortiSwitch v6.4
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sflow or netflow don't need licenses, the configuration only shows the collector IP, you also need to speficify the port number and then enable sampling under the interfaces.
config switch interface
edit "port''
set packet-sampler "enabled | disabled"
set packet-sample-rate 'count'
set sample-direction 'rx | tx | both'
set sflow-counter-interval "interval''
next
end
Suraj
- Have you found a solution? Then give your helper a "Kudos" and mark the solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you ,
but i can found these commands under the port configuration
set packet-sampler "enabled | disabled"
set packet-sample-rate 'count'
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Below given is the config guide for 7.4
https://docs.fortinet.com/document/fortiswitch/7.4.0/fortiswitchos-administration-guide/741913/sflow
Suraj
- Have you found a solution? Then give your helper a "Kudos" and mark the solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
sFlow is not supported by 124E. Has to be either 124F or 148E for the 100 Series.
https://fortinetweb.s3.amazonaws.com/docs.fortinet.com/v2/attachments/04cb1b8c-009d-11ee-8e6d-fa163e...
Toshi
