Hello Team,                 We are deploying two FortiGate 100F firewalls in an Active-Passive High Availability (HA) configuration with a Stack of two Cisco Catalyst 9300L switches. One of the LAN interfaces(Port 3 & Po...

Hello,I’m encountering a persistent issue on my FortiWeb device. In the logs, I consistently see entries like: Main Type=HTTP Parsing Error, Sub Type=HTTP Parsing Error Action=alert_Deny To troubleshoot, I ha...

Hi Team, I have configured In-band management access for taking the access of both Pri and Sec devices from different network but I am only able to take access of primary device not secondary. I had checked in the sniffe...

Simple question.  Should I be concerned that one FortiGate 101F consistently runs at 60% - 75% memory used, while a like 101F with a significantly larger network and hardware load uses 25% - 35% of memory on a daily aver...

HI Team, We have recently implemented FortiGate 200G firewall to replaced SonicWALL. Will before used one of the feature is not working in FortiGate i will raise ticket support team and confirmed they it will work like y...

I am able to connect to my IKE v2 IPsec tunnel for remote access using my local laptop plugged directly in to internal1 port, however I cannot ping lan (VLAN gateway 172.16.10.1) that sits behind FortiGate. FortiOS versi...

HiI lost access to the web ui of the fortigate fw after changing the ha settings from active-passive to standalone. As soon as i selected standlone and clicked OK, fw starts buffering for sometime and then i lost the web...

I made a GNS3 lab with 1 Fortigate (as a gateway) and 2 PCs:Structure:1. PC1 -> Fortigate (Port1).2. PC2 -> Fortigate (Port2).Configurations:Fortigate:config system interfaceedit "port1"set mode staticset ip 10.0.0...