Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
MustphaBassim
New Contributor III

Trunk Port on FortiSwitch

Hello Dears

 

I am trying to perform trunk with cisco interface on fortinet switch 148F , i did the configureation required for trunk as show below but it is not working anyone can help plz? i think the issue is unable to change to dot.1q it's working isl

 

config switch trunk edit "Trunk" set members "port2" next end

 

Bests

13 REPLIES 13
ebilcari
Staff
Staff

There is a difference between the naming of different vendors. If you have only one physical port connecting the switches you don't need to configure a trunk in FSW. The term "trunk" in FSW is for link aggregation.

Just set a native VLAN and the allowed VLAN that you need on the uplink port.

 

From Cisco side you have to configure the interface as trunk mode (switchport mode trunk) set the native VLAN and allow the VLANs that you need to pass.

 

Take a look at another related discussion: https://community.fortinet.com/t5/Support-Forum/Connected-148F-Switch-to-Cisco-2960X-Traffic-wont-pa...

- Emirjon
If you have found a solution, please like and accept it to make it easily accessible for others.
MustphaBassim

hello dear

 

i did that but it is also not working

jackpr

Dont configure the port as a trunk. You simply just need to allow the VLANs you want to pass.

 

Ignore the concept of access and trunk ports - thats not applicable here. Trunk, as mentioned above, is set to do LAG.

MustphaBassim
New Contributor III

Capture.PNG

I did the configuration like that but no luck

jackpr

Can you show cisco config?

MustphaBassim
New Contributor III

SW(config)#interface g1/0/24

SW(config-if)#switchport mode trunk

SW(config-if)#switchport trunk allowed vlan 21

SW(config-if)#switchport nonegotiate

jackpr

Okay - so you are only allowing vlan 21 on the Cisco side, but allowing 1-4000 on the FSW - is this by design?

 

If so - where does the SVI for VLAN 21 live? What is not working?

MustphaBassim
New Contributor III

The SVI on other device trying to reach a user on VLAN 21 AS SHOWNUntitled.png

MustphaBassim

I see also the switch is not being added to fortigate firewall controller it is looks offline

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors