NAT port forwarding

[nabs]

Hello

I am new to Fortinet and currently stuck on something very simple and would need some help.
I am simply trying to enable port forwarding from the WAN interface to the LAN interface so that if a request comes in on a WAN interface on a particular port the request gets forwarded to the local device on the LAN. Have setup as below:

The problem is when I try to access on the wan IP (192.168.70.34), I am not able to access the RDP server. Not sure what I am missing here but glad if someone can help on this.

I have checked the guide on the below link but st

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Virtual-IP-VIP-port-forwarding-configurati... 

Thanks

[Toshi_Esumi · Accepted solution]

The "Destination" of the VIP policy needs to be the VIP "RDP" you configured. In the KB's case it's "Test". I don't recommend enabling NAT on the policy unless you need to hide the source IPs before delivering the packets to the server.

Toshi

[nabs]

Good spot. Just that one single change and it worked. I have also removed the enable NAT on the policy, basically I was trying everything to check and see if it could make it work.
Thanks