- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Link-monitor specific route
Hello everyone!
Is there someway to attach a 'link-monitor' to a specific static route??
The feature "set update-static-route enable" just remove ALL the routes rellated to an interface.
I was looking for something like Cisco track, that you can attach to any static route.
Thanks in advance.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In essence it is the same as the Cisco track feature. In either way you are monitoring a destination server.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In essence it is the same as the Cisco track feature. In either way you are monitoring a destination server.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes and not, I guess.
Yes, it can monitor a destination IP... (with "link-monitor" on Fortigate, or "IP SLA" on Cisco)
But with Cisco it could attach the "sla/track" individually on each route, but with Fortigate it just remove ALL the routes related to that interface.
This is a problem cause Fortigate is acting as MPLS concentrator in my topology. I need to clear only the routes that are not answering to the "link-monitor" not all routes on that MPLS.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you ever get an answer to this as I need to do the same thing, remove a single static rather than all statics associated with an interface?
