- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fortigate IPSec traffic issue
Hello,
We have 2 virtual fortigates - one is deployed in Azure environment, second in our local datacenter on ESXi infrastructure. On these 2 fortigates we have installed trial licenses (provided by vendor). We have configured IPsec over GRE between these 2 fortigates. Connection is stable but speed is very low, maximum in peak was 15 mbp\s. Not sure there is the problem..
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Use the following doc to troubleshoot : https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-How-to-troubleshoot-speed-or-bandwid...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@1mm try to force nat-t under ipsec phase1 config
Technical Tip: IPSec VPN nattraversal - Fortinet Community
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would suggest setting up a lower TCP-MSS ~ 1350 for both directions .
This is recommended for IPsec tunnels on FGTs hosted in Azure Cloud
https://docs.fortinet.com/document/fortigate/6.2.15/cookbook/255100/ipsec-vpn-to-azure-with-virtual-...
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Setting-TCP-MSS-value/ta-p/194518
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for your replies,
I have one question, can it be referred to trial license? Are there any limitation of trial licenses provided by vendor?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@1mm , Based on my knowledge, we do not impose any resource limitations for trial licenses.
