- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please check the configuration for local users on both the FGTs in cluster.
Command 'show user local' should highlight the config.
Please compare both and see if the config matches or not.
Thanks and regards,
Shahan Agha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please check the configuration for local users on both the FGTs in cluster.
Command 'show user local' should highlight the config.
Please compare both and see if the config matches or not.
Thanks and regards,
Shahan Agha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You can try to re-calculate checksum and see if it helps:
#diagnose sys ha checksum recalculate
Otherwise you can refer following :
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Procedure-for-HA-manual-synchronization/ta...
#diag sys ha checksum cluster
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Excelente, soluciono un problema que tenia! Gracias
