FortiSwitch 1024D Transceiver issue.

[DsB]

Hi i am new to this, i have a FortiSwitch 1024D that can only indentify the transceiver on any given port after a reboot.

Is there a command that can refresh or reset a transceiver on a port?

Regards.

[rgracioli_FTNT]

Hi,

It's not necessary to reboot FortiSwitch for a transceiver to be recognised. Make sure you're using a compatible transceiver (https://docs.fortinet.com/document/fortiswitch/6.4.4/fortiswitch-compatible-transceivers). 

[DsB]

Hi, the transceiver is SFP1G-LX-31 1000Base SFP 1310nm 10KM, is this compatible with this unit?

Regards.

[rgracioli_FTNT]

Hi, the type mentioned is supported, but you may be using a transceiver model that is not MSA compliant. I suggest that you open a case with support to have it checked. 

[DsB]

Is there a command line that can help me check that?

I have notice the following error in the events of the fortiswitch "failed BASE ID Check Sequence" in the port where the transceiver is connected.