- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FortiGuard DDNS cannot update IP address
FortiGuard DDNS 無法更新 IP 地址
視差
無法使用域名
- Labels:
-
FortiDNS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Same here, all tricks faq not working
Public IP is not updated
Problem since yesterday in the evening and on fortios 6.4/7.0 on multiple different devices
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
today, all was fine again
Would be nice if someone from Fortinet could explain it.
I can not imagine, that this was not a kind of outage, and, as most usual, the information about it, comes late or even at no time. Not the best customer service at all
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@LouieLu can you confirm, it is working at your site, again, too?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I suppose that something with the anycast system maybe was down
I found out, it can be changed like this
Switch to other Anycast servers:
# config system fortiguard
set fortiguard-anycast-source aws
end
However, what is the default on it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @Secucard ,
The default when we enable any cast will be Fortinet.
config system fortiguard
set fortiguard-anycast enable
set fortiguard-anycast-source fortinet
end
article steps used when it is not reached by default enable
Regards,
Manasa
