FortiGate

kulas · ‎02-21-2018

Hi,

I'm just a newbie when it comes to Fortigate configuration. This may sound dumb question, so please bear with me :)

Is it possible to establish IPSec Site-to-Site VPN both sites uses PPPoE internet? Both PPPoE modem was set to bridge mode. We are trying to establish a VPN between Fortigate and Cisco RV345 (if I'm not mistaken with the model)

Any comments will be highly appreciated. Thank you.

Hosemacht · ‎02-21-2018

Hey Kulas,

just have a look in the cookbook:

http://cookbook.fortinet.com/ipsec-fortigate-cisco/

Regards

sudo apt-get-rekt

ede_pfau · ‎02-21-2018

Yes, that is possible. In fact, PPPoE is the most common WAN protocol over here and I've set up quite a few site-to-site VPNs over PPPoE links. If the site is not using a static IP address, you can use dynamic DNS gateway names in the VPN setup, even on both sides.

Ede

"Kernel panic: Aiee, killing interrupt handler!"

kulas · ‎03-04-2018

Thank you for this. We will look for the configuration of DynDNS on the Cookbook. Regards.