- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
600Fs active-active HA to Cisco Nexus 9Ks NX-OS
I have two 600Fs in active-active HA that will be connected to two Cisco Nexus 9K NX-0S in a vPC domain.
I am new to FG attempting to determine correct port settings on the 600F for a redundant inside interface with the goal being if either N9K or 600F goes down, traffic will still flow.
Currently I have port x6 on both 600Fs connected to each N9Ks port Eth 1/2
Primary 600F port x6 – switch 1 N9K port 1/2
Second 600F port x6 – switch 2 N9K port 1/2
The N9K ports are setup as vPC/port-channel
What is the correct interface settings on the 600F to support this or is this not supported?
Thanks much for any guidance.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Larry,
Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.
Thanks,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Larry,
We are still looking for someone to help you.
We will come back to you ASAP.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you have single links from each FortiGate (sounds like you do—x6) then it's just a regular interface no special configuration needed.
If you want to do LACP to your N9K from both Firewalls (so you can have a Nexus switch failure and not have your FortiGate HA failover too) then you can do this with an Aggregate link type.
Graham
