| Description | This article describes how to configure SD-WAN rules and performance SLA for time-sensitive applications. |
| Scope | FortiOS 7.0.11,7.2.5 and 7.4.0 and above. |
| Solution |
Some applications are very sensitive to network quality hence they would need to be set up with a lower-performance SLA check interval for better convergence.
In the below example:
Policy 1 VOIP is set up to use the best quality link with the performance SLA check interval of 20ms for packet loss so a better convergence rate is achieved:
Note: The default performance SLA value is set to 500ms and that can be reduced to 20ms from FortiOS 7.0.11,7.2.5 and 7.4.0 and above which is recommended for time-sensitive applications.
CLI for the above performance SLA interval:
config system sdwan end end |
