Description
This article describes how to configure logging in memory in later FortiOS. Logging can be enabled by using either the GUI or the CLI. Both of them have been changed from previous releases. The configuration of logging in earlier releases is described in the related KB article below.
Scope
FortiGate
Solution
From WebGUI:
1) Log into FortiGate.
2) Go to Log & Report -> Log Settings menu (if Virtual Domain is Enabled, set it under each VDOM).
3) Refer to Local Log -> enable Memory.
4) Select Apply.
Enable log memory via CLI:
# config log memory setting
set status enable
end
Set the Log level via CLI:
# config log memory filter
set severity information
end
Related Articles: Technical Note: How to configure logging to memory in FortiOS v5.0
