Meru Technical Note - How to reset the captive portal files to default files (Factory Condition) when using CUSTOM mode
How to reset the captive portal files to default files ( Factory Condition ) when using CUSTOM mode.
Scope
KB Article Type: Configuration
RELATED PRODUCTS: Controller Platforms
RELATED SOFTWARE VERSIONS: 4.0 and above
KEYWORDS: captive portal, default, custom mode, captive, custom default
Solution
Scenario :
You have configured captive portal to work in Custom mode. Captive portal will use files in custom folder inside the file system and will ignore the files stored in the default captive portal page.
If it requires for you to restore the files in the custom folder to its factory default, you must follow the below steps. Following the below steps will delete all the existing files in the custom folder and loads the files as per the factory condition.
Steps :
Go to Maintenance ---> Captive portal ---> Customization ---> Check whether CUSTOMIZED mode is selected ---> (IF YES), Select option RESTORE DEFAULT.
The above steps will perform the task as mentioned above. Now custom folder will have all the default files in factory condition.
