Meru Technical Note - How to enable 10 gig on the Controller

How to enable 10 gig on the Controller?

Recommended steps to configure the 10gig module.

Step1: Insert the 10 gig SFP module onto the controller. 
Step2: Import the 10 gig license on to the controller.
Step3: Reboot the controller.
Step4: Configure Switch side for the fiber interfaces.
Step5: After controller reboots, Enable the 10 gig using below commands:

               Controller# Config termainal
               Controller(config)# 10gig-module enable
               Controller(config)# exit
               Controller# reboot Controller
               
Step6: After the Controller has been rebooted, the 10 gig module will be configured.