Hi, I read that the NP6XLite processor ensures hardware acceleration of
network traffic, which enables the processing of large volumes of data
without heavy CPU load. This acceleration mainly applies to basic
functions such as routing, NAT, IPsec, an...
Hi, we upgraded our core network by replacing the core firewall with
FortiGate-600F and Aruba Switch 8360v2.The issue is with the
interconnection between the FortiGate and Aruba switch. The 25 Gbps port
(x5) on the FortiGate-600F is not working when ...
Hello,I need advice on a problem, or to make sure that this is indeed
the case. I have a FG VM in a cluster (FortiOS 7.0.14) and I updated the
license from 2CPU to 4CPU but only on the Master (Master 4CPU, Slave
2CPU). HA worked correctly and everyth...
Hello everyone, the FortiManager has 2 IP addresses and the FortiGate is
authorized to IP 1 in the Security Fabric/Fabric Connectors/Central
Management Settings but I need to change the authorization to IP 2. How
do I do this? If I use: config sys ce...
Hello, I am interested in one question to which I have not found an
answer. If I have a 2FA to log in to FortiCloud (2FA with email or
FortiToken Mobile) and I lose access to the mail that the authentication
code comes to or lose the mobile that has ...
if the DAC cable is connected to port x5 and x6 (LOOP), then the ports
work: ==[x5]mode: staticip: 0.0.0.0 0.0.0.0ipv6: ::/0status: upspeed:
25000Mbps (Duplex: full)FEC: cl91-rs-fecFEC_cap:
{cl91-rs-fec,cl74-fc-fec}==[x6]mode: staticip: 0.0.0.0 0.0.0...
Hello, thanks for your advice... but one thing I don't understand: FG is
VM64 (not VM04) in HA and the licenses have the same subscription. The
only difference is that the Master has 4 CPUs and the Slave has 2 CPUs.
The strange thing is that after up...
If I use the command:config sys centralset type fortimanagerset fmg "new
IP"end will I not lose the interface and configuration and the FortiGate
will be authorized to the new IP address of the FortiManager? I'm a bit
afraid of losing the configurati...
Hi Bill, I have FG101F-7.2.6. AV was configured to Proxy-based, so I
switched to Flow-based but nothing changed. When downloading a 500MB
file from Google Drive, FG is still obviously caching the file and goes
into memory conserve mode.
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
