Hello good morning. Please, I wanted to ask the following question. I
have a router connected to port 5 on my Fortigate in the following IP
range: 192.168.30.100/24. On the other hand, I have on port 3
(configured as an interface) an output to a swit...
Hi.I have disabled from being able to ping my public IP. Please, I
wanted to know if it would also be possible to not be able to telnet to
the public IP and port that I have open for VPN. If not, does this
represent a security risk? Thank you.
Hi.I wanted to ask you about the following problem I am encountering:I
have a Fortigate 80E device with one of the internet outputs via fiber
(Wan1). The second is WiMax and it is what we use to give our company's
clients free Wifi (Wan2). To access ...
Hi,I'm sorry for the delay and inconvenience caused.In the end,
everything was configured correctly, the only thing left to do was
configure the 192.168.30.100 gateway on the side of ports 3 and 5.Thank
you all for your collaboration. A cordial greet...
Hi,1) When you are trying to ping from the source to the destination do
you see the logs in the traffic logs of the Firewall? NO- Have you tried
to check the sniffer/packet capture on the firewall when performing the
testing?This is what i get:Fortig...
Hi,1) Is the router allowing mulitple IPs from the same 192.168.30.0/24
subnet on multiple ports? YES2) It's odd. I'm almost sure you can't ping
192.168.30.102, .301, and .302 from the FGT.I don't understand you well,
from the commands that you indic...
