Hi, I have 3 WAN interfaces:WAN1: PPPOEWAN2: Trunk port (with 2
subInterfaces + Public IPs)WAN3: PPPOE When all of the WANs are
functioning properly, I use the CLI on the FortiGate:"execute
ping-options source "and try"execute ping
8.8.8.8"Then, only...
Hi @DPadula, When i remove out WAN1 and WAN3 of out SDWAN, only WAN2 in
SDWAN then ping-option source IP_WAN2 is a success. Yes, when I applied
SDWAN rule to a PC connected to Internet through WAN2 and it was still
fine.
Yes, I did. It's successful when ping to the gateways in WAN2.There are
2 subnets:Sub-Interface name Network Usable Host Range Gateway
wan2.sub-interface-1 11.11.11.240/29 11.11.11.241 -246 11.11.11.241
wan2.sub-interface-2 11.11.11.248/29 11.11.11.2...
Hi @DPadula , I tried your guide and the outcome below://SDWAN config
config system sdwan set status enable config zone edit
"virtual-wan-link" next edit "SDWAN-01" next end config members edit 2
set interface "internal7" next edit 3 set interface "w...
I've tried some scenarios, and there's a new process.When i remove out
WAN1, and WAN3 from SD-WAN, only WAN2 ( 2 sub interfaces). Then the
ping-option with WAN2 IPs is a success and i don't know why!I also can
not clearly understand the results.Could...
