I am setting up a new Fortigate 200D on 5.2.3 I need to restrict
internet access to a small number of sites. In the past I have done this
2 different ways: 1. Custom Categories 2. URL filter Which way is
generally more efficient and are there any pro...
Hi - I am having a problem with a FortiGate 200B unit. At the present
time I am unable to access the unit via HTTPS which is how we have been
accessing the unit for many years now. I am able to Telnet to the unit
but upon loggin this is what I am pre...
Hi - On the status GUI my Fortigate 60 C shows v5.0,build3608 (GA Patch
7), but when I click on " details" next to it the window that comes up
shows: FGT60C-5.00-build271 If I look at the config file I see:
#config-version=FGT60C-5.00-FW-build271-140...
We have IPSEC tunnels connecting our Fortigate 200B at our main site to
Checkpoint Firewalls at 2 remote sites. The tunnels are not in interface
mode. I want to be able to have users connect to our main site using
either PPTP or SSLVPN be able to acc...
I am having some trouble getting an Interface mode VPN up and running.
At the current time the tunnel is showing as up but we are not able to
pass any traffic over the tunnel. I have double checked the policies on
both units and I have 1 for inbound ...
I do have a spare unit that is factory defaulted. Is it possible to pull
a config file off of the unit I am having a problem with during the boot
phase ?
Thank you for the quick response. Did your units ever get past the "
Auto backup config ..." I am nervous about rebooting and would prefer to
do it by sending a command to the unit rather than just pulling the
plug.
Thank you. The drop at line 6 is me bringing the tunnel down and then
back up. I did try putting info into the source and destination address
under the quick mode section on the advanced section of P2 parameters
but that has not worked. Below is the ...