Hi I have a weird behavior and can't find the reason.I have FGT 300E and
FAPs 432FR and even if AP got IP address and all wireless controller
settings are ok, FortiGate not showing FAP in GUI. If I add it manually
then after few sec is onlineThe same...
Hello.I need setup redundancy paths between FS but one link should be
over fiber and second via WiFi bridge build on FAP (mesh config
ROOT-LEAF). main problem is that fortilink over fiber is automatically
formed but via APs I have to tenable p2p-fort...
Hello All members. I would like to ask you how to check current port
utilization on switch managed by Fortigate with ver 6.4.14.I found some
statistic on ver 7 but need on 6. It could be even from CLI.is this can
be visible from FG level or directly ...
Hi ALL I have question , and maybe someone from Fortinet can answer. I
have HA FG300E ( 2 devices) but we need to install more switches then
one unit can support. And the question is how Cluster manage total
supported devices. Is it still 72 or is 2x...
Hello All. I need to deploy Fortinet solution in small factory ( FG, FS
) and I have a question , How to connect exist ring to MCLAG cluster (
this red Ring ) - Can I mix Ring redundancy with MCLAG redundancy ? or
option 2 ofc in this ring will be mo...
Hi. today I got some time to check this setup and now it is something
weird.Already added copper link instead for fiber and this link is not
forming trunk . for test I enabled fortilink-p2p additionally on ports
on both switches where copper is conne...
HelloI tried Fortilink and P2P-Fortilink and when I connected fiber port
all switches went down, so had to disconnect again to bring then
online.do you have any example of config. For classic fortilink is
nothing to config because is formed automatic...
question because in documentation I found this Do not change the HA mode
from A-P to A-A when set logical-sn enable. This will result in the
FortiGate losing its vSN. Disabling logical-sn will also result in
losing the vSN. As a result, service entit...
