Starting with FortiOS 7.6.3, the SSL VPN tunnel mode has been replaced
by IPsec. I have prepared a consolidated document that outlines the key
steps and configuration required to set up IPsec VPN for remote users
using SAML authentication. This singl...
We have fortigate firewalls & EMS server for Forticlient management. We
are using several FortiAPs. We want to use certificate-based
authentication for wifi users. I know we can achieve it by using EAP-TLS
802.1x and radius server. Is there any way w...
Hi,We have ZTNA environment in which EMS is installed. There is AD
integration with EMS server so currently we are authenticating
administrators with AD. We have OKTA setup as MFA for VPNs and etc.We
want to implement OKTA as IDP (SAML) for EMS admin...
Hello Everyone,I want to implement 802.1x authentication on wifi users.
We have FortiAPs managed by fortigate. I want to use device based
authentication with certificate. If certificate exist in laptop/MAC then
only users can connect to wifi.I have g...
Hi All, I am planning to enable heuristic scan option in antivirus
setting. I have gone through document where it says I need to enable it
like,configure antivirus heuristic set mode block For higher
models,config antivirus quarantineset drop heurist...
Hi,Just wanted to check—are you currently using an HTTP request for the
health check (SLA) for microsoft? If yes, please try switching to PING
or another protocol, as Microsoft blocks HTTP requests.
Hi,Please assign ikse-saml-server name on LAN interface where LAN users
connects. Please follow below
thread,https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-IPsec-SAML-VPN-connection-failure-when/ta-p/429936
Are you looking for FortiClient VPN setting in EMS? if so may be below
URL will be
helpful.https://docs.fortinet.com/document/fortigate/7.4.4/ssl-vpn-to-ipsec-vpn-migration/477942/forticlient-endpoint-configuration-migration
We have tested the same scenario last week successfully.FGT -
7.4.9FortiClient - 7.4.3Dialup IPSEC VPNAuthentication - SAML set
auto-asic-offload setting is enabled and it is working as expected
Hi,I am considering you are running on version 7.4.x 1. configure SLA
performance with ping or https protocol e.g protocol - ping, server -
google.com2. create SD-WAN rule, map required SLA target, select "Lowest
Cost" as interface selection strategy...
