Hi, I'm trying to redistribute OSPF over BGP. The Neighbors are getting
the routes but the routes are using wrong recursive next hop IP on one
of the sides... When you look at the routing table on the right side it
is using the WAN IP instead of the ...
Hi all,I would like to express my gratitude for your assistance in
resolving my issue. Your time and support have been greatly
appreciated.Upon reflection, I realized that I neglected to perform a
simple ping test between the sites after resetting bo...
Hi Adrianphase1-setting doesn't seem to exist. So here is the interface.
On the HUB site its called "ADVPN-HUB".DKAAR-FW01 $ show vpn ipsec
phase1-setting ADVPN-HUBcommand parse error before
'phase1-setting'Command fail. Return code -61DKAAR-FW01 $ s...
No 172.30.0.254 is the VPN hub interface on DKAAR-FW01 see updated
picture below. the difference between the two routes you mentioned is
that the 172.21.0/30 is directly connected and the 10.1.2.0/24 is a
redistributed route via bgp.
DKAAR-FW01:DKAAR-FW01 $ get router info bgp neighbors 172.30.0.1
advertised-routesVRF 0 BGP table version is 8, local router ID is
172.30.0.254Status codes: s suppressed, d damped, h history, * valid, >
best, i - internalOrigin codes: i - IGP, e - EG...
Hi Faiza,Thanks for the response! 1. Check BGP configuration on the
right side FortiGate device: Verify that the BGP configuration on the
right side FortiGate device is correct and that the tunnel interface is
specified as the next hop for the redist...
