For some reason, my Fortigate 40F (v7.0.13 build0566) is losing the date
and time settings when it loses power (maybe the battery is dead) and
when the power comes back on, the Fortigate displays the message
"Fortigate time is out of sync". I have al...
Hello! Our fortianalyzer stopped displaying logs 2 days ago. I am using
fortigate with version 7.0.13 build0566 and fortianalyzer with version
7.6.3.From the fortigate graphical interface I can successfully run a
connection test with fortianalyzer. H...
hi Let's say I have an SD-WAN rule based on the MANUAL strategy. This
SD-WAN rule has two interfaces (WAN1 and WAN2), with WAN1 being the
interface that was added first and therefore becomes the preferred
interface for internet communication. If the ...
Hello I have a question: when using SDWAN rules with Maximize Bandwidth
(SLA) or Best Quality strategies, what happens to sessions already
started on an Internet link that no longer meets SLA requirements? Are
these sessions terminated by Fortigate o...
Hello I created a Performance SLA to monitor the quality of a link to
connect to a specific server on the Internet. The measurement uses
tcp-connect and makes requests to a specific IP and Port. The defined
check interval is 500ms and the time to con...
I think my internet provider is blocking source port 123. When enabled,
NTP uses the valid IP of a WAN interface and default source port 123 for
the NTP request. I will validate this with my internet provider. Just
out of curiosity, I tried to set th...
And I ran the command "exec sql-local rebuild-db" and the result of the
command "execute log fortianalyzer test-connectivity" changed and now
the information of received logs appeared again "Log: Tx & Rx (290 logs
received since 07:46:16 05/28/25)". ...
I configured a raspberry to simulate a bad link using the TC tool, I
increased the latency and packet loss so that the link no longer met the
SLA and apparently the session remained active on the link that no
longer met the SLA requirements.
