I am trying to use the internal management interface on a standalone
FortiSwitch. How would I configure this for a static IP? The basic
scenario is a FortiSwitch connected to a Cisco switch acting as the
Core. VLAN 1 is native on the uplinks, VLAN 15...
There is a separate department where I work that purchases licenses and
bills them to the proper cost centers. Am I able to create a separate
account for them (there is already an email that exists for these
situations)? If not, is there an alternati...
This is a FortiSwitch 248E-FPOE. I have replicated the issue with
another switch. The switches were on 7.2.1 and I tried to upgrade one to
7.2.4. After I noticed the issue, I upgraded another to 7.2.3 with no
issue, and then to 7.2.4 where the issue ...
Hello. I have some test switches (248E-FPOE). I put them into standalone
mode (factory reset and then reconfigured). Some of the switches are on
7.2.1 and others on 7.2.4. The switches are connected to each other, and
only each other. There are no re...
We had to make the purchasing account the master user. Kind of
ridiculous, but it seems only the master user is able to renew licenses
online like this.
After I tried what you said and it did not work, I looked at the gateway
and realized it was configured with the wrong subnet mask. In fact,
every single management IP was configured incorrect *(from before my
time) because no one ever went back and ...
By reconfiguring the switches mostly from scratch (still reusing vlan
and port configurations) I was able to solve this. My best guess is that
there is some configuration from managed switches that will cause CPU
spikes if applied to a standalone swi...
As per a ticket, this is a bug set to be fixed in the 7.4.1 release. A
current work around is to just disable strong-crypto and then reboot or
kill the ssh process.The ticket was resolved a while ago, but since I
already logged in, I see no reason to...
Hello, May I ask for some support on another post I made. It is
hyperlinked here -> other post. It received a reply, but I was unable to
resolve any issue with it. Thanks.
