Technical Tip: Low-end FortiGate models with RAM ≤...

majid23 · 11-05-2025

Description This article describes how to configure Local ID on spoke FortiGate devices to match its hostname in a Dialup Hub-and-spoke IPsec VPN setup. This can assist an administrator to identify each spoke during troubleshooting, especially when m...

majid23 · 10-19-2025

Description This article describes the new http_authd daemon in FortiOS 7.6.4, which enhances administrator authentication and session handling for connections to the FortiGate GUI. Scope FortiOS 7.6.4 and later. Solution In earlier FortiOS versions,...

majid23 · 09-19-2025

Description This article describes an issue observed on FortiGate devices running v 7.4.7 and v7.4.8, where duplicate FortiSwitch entries appear in the Managed FortiSwitches section after transitioning from standalone mode to HA Active-Passive mode. ...

majid23 · 12-05-2024

Description This article describes that to integrate FortiSwitch with FortiGate and FortiNAC, syslog logs might not be properly transmitted from FortiGate to FortiNAC. This can result in missing MAC address events, such as Add, Delete, and Move, in F...

majid23 · 01-22-2024

Description The article describes how to check if a FortiGate is going into conserve mode due to an increased ISDB database. In October 2023, the size of the ISDB increased significantly raising the risk of lower-end FortiGate hardware units entering...

User Statistics

User Activity

Technical Tip: Using Local ID for easier identification of spoke FortiGates in a Hub-and-Spoke VPN deployment with preshared key

Technical Tip: In FortiOS 7.6.4 and later, administrator web authentication is handled by the http_authd process

Technical Tip: Redundant FortiSwitch Entries Observed on FortiGate After Enabling HA

Troubleshooting Tip: FortiGate and FortiNAC Integration in FortiLink Mode Using Syslog Messages