Hi all, I hope you can help me. I'm having an issue with our
FortiManager and a conflict which is preventing us from getting the
firewall to a synchronised state. Below is the ssl-ssh-profile and the
configuration which it is trying to push, the prob...
Hi all, I hope you're well. Hopefully you can help me, I have
security-fabric running across multiple FortiGate firewalls and I have
noticed that we receive no alerts from triggered automation stitches on
our downstream firewalls. At present, I have ...
Hi all, I hope you're well. I am having issues connecting our branch
firewalls to our fabric root FortiGate. All the configuration is correct
as prior to upgrading all firewalls to 7.4.7 this was working just fine.
Post upgrade to 7.4.7, we found tha...
Hi all, I hope you're well. I am migrating a site with existing Cisco
switches to FortiSwitch but will not be using the default FortiLink
interface since the VLAN's are already created under the existing
aggregate interface. Templates have been confi...
Hi all, I hope you're well. I am testing FortiSASE and have setup and
working as I would like however, I would like to run some alternative
IPsec VPNs as well as the SIA into FortiSASE. Within the SASE portal I
have added the IPsec VPN into the "VPNs...
Hey @dingjerry_FTNT, I can confirm this has allowed this option to be
displayed and therefore installed via FortiManager however, I now have
an issue with config SSL: When checking in the CLI, in the config SSL
settings within the ssl-ssh-profile the...
Hi ap, Thanks for that. I was worried that it may have affected
something else and caused issues. If this only changes configuration
related to FortiAnalyzer, FortiSandbox and central management I will
give this option a try and see if this resolves ...
I've just tested this on my lab firewall running a similar setup with
version 7.2.10 and this command is available: However, this isn't the
case for my firewalls running 7.4.7 therefore, something must have
changed and it either needs to be enabled s...
Hi @dingjerry_FTNT, I have a lab firewall that is running a similar full
SSL setup with 7.2.10 installed, when running the same commands in the
CLI, I can see I have the min-allowed-ssl-version available: Not sure
why I cannot see this on my firewall...
Hey @sw2090, Thanks for your response. It's very weird, I have tried
within FortiManager setting the min-allowed-ssl-version to tls-v1-1 but
unfortunately it gave me the same error. It seems as though my problem
is that the command doesn't exist in t...
