Hi, I have a problem with firmware upgrades of a FGT-Cluster.A part of
the configuration gets lost after upgrading the firmware of the
cluster.I don't even know the steps/update path of the last time.But
this time the upgrade was from 7.2.3 to 7.2.4....
Hi, I have an issue with use of VRFs.I configured the FGT like descriped
in the following instruction:
https://docs.fortinet.com/document/fortigate/7.2.3/administration-guide/752950
The FGT has two IPsec tunnels, one for primary and one as backup.All...
Hi community, I have a problem regarding authentication via TACACS+ on
FGT units (FGT40F).I have two WAN interfaces, but their're no members of
a SD-WAN. If the primary interface goes down, the login via TACACS+ is
not possible anymore.Also I configu...
Hi Graham, sorry for the late reply. Routing table when both WAN
interfaces are up:# get router info routing-table allCodes: K - kernel,
C - connected, S - static, R - RIP, B - BGPO - OSPF, IA - OSPF inter
areaN1 - OSPF NSSA external type 1, N2 - OSP...
Hi AEK, sorry for the late reply.I also read that, I mean that VDOMs are
the better solutions instead VRFs.Acutally VDOMs and VRFs are not the
same, but if it helps... I will check it out :) Big thanks
As already suspected, the save mode was the cause of the configuration
loss.But the problem occurs only, when it's a cluster.A standalone
device, which has save mode manual, can be updated without any problems.
Final words: Save mode "manual" and Clu...
Hi knagaraju, at the first time the update path was followed correctly.I
can't just remember the step(s).Or is there any history on the FGT,
where I can look up after that? hostname # show full system global |
grep cfg-saveset cfg-save manualhostname...
Helpful article:
https://docs.fortinet.com/document/fortigate/7.4.0/administration-guide/432685/manual-redundant-vpn-configuration
There is a further option for the secondary tunnel "set monitor
.The backup VPN stays down as long as the
primary one i...
