I just took over the previous IT person and I was wondering if someone
could guide me in how to enable to WEB-GUI on my S248EF. FortiLink
InterfaceLinkUPPort SpeedAuto-NegotiationType802.3ad AggregateIPv4
Addresses169.254.1.1/24Members A BManaged Dev...
How do I reset my Fortigate 200D with the Reset Button? I have tired
multiple times, but the old settings are still there. Could someone help
me out please? Thanks
Hello @ebilcari So, the day I change and replace the switch, I will just
follow the part where is says: To replace a managed FortiSwitch unit
when split ports are not enabledThank you so much.
Hello @anignan This is what looks like my Switch FortiSwitch-Main
(interface) # show full-configuration config system interface edit
"mgmt" set mode static set dhcp-relay-service disable set ip 0.0.0.0
0.0.0.0 set allowaccess ping https ssh set bfd d...
Hello @anignan In the steps in how to replace a Switch, it says: To
replace a managed FortiSwitch unit when split ports are not
enabled:........To replace a managed FortiSwitch unit when split ports
are enabled:...... So, I was wondering... How do I ...
Hello @anignan @ebilcari , Is there a way to check from my FortiGate if
the Switch has split ports enabled/disabled? Is in situation like this
one that I would love to have the WEB-GUI working on the Switch.
Hello @anignan I just tried again to connect to the MGMT port via an
Ethernet cable without success. Management computer:IP address:
192.168.1.2 Netmask: 255.255.255.0Default gateway: 192.168.1.1 Preferred
DNS server:Alternate DNS server: Switch Fort...
