I know how to use the FortiGate GUI to run a Cable Test diagnostic on a
given interface, but I need to know how to do the same thing via
FortiGate CLI. Does anyone know the command for this?
I'm referencing what the GUI calls a Cable Test under Diagnostics &
Tools. Its the one that tests a given interface to see if there are wire
pair issues or shorts on a line.
Ok thanks, you've confirmed some suspicions I had from recent reading.
Also in this example, I'll be using two FGT-600Fs ;) Last question -
after MCLAGing those two 1048Es together, would they still show up as
two different switches in the FortiGate'...
What's your advice on the optimal way to connect two FGTs in HA to two
distribution FortiSwitches (1048E for example) in a Two-Tier topo? I
like the idea of all Layer 3 traffic going to the FGT, but would want
Layer 2 traffic to just switch without t...