Technical Tip: SSL VPN Monitor shows web connectio...

Rajneesh · 09-25-2025

Description This article describes that the external threat feed connector is not showing in the firewall policy. Scope FortiGate v7.6.x. Solution In the attached image, it can be seen that the external threat feed address object is not showing in th...

Rajneesh · 07-10-2025

Description This article describes the reason behind unknown status of the interface’s showing in SD-WAN monitor. Scope FortiGate. Solution In the attached image the status for port 1 and port 2 is shown as Unknown. The interface status shows as 'UNK...

Rajneesh · 07-09-2025

Description This article describes the use and impact of the password policy configured on the existing IPsec tunnels. Scope FortiGate. Solution The configured expiration policy exclusively applies to administrator logins. IPsec pre-shared keys are n...

Rajneesh · 06-04-2025

Description This article describes an issue where users connecting to the IPsec remote VPN are not redirected to the SAML IDP for authentication. Scope FortiGate. Solution When the user is trying to connect to the IPsec remote VPN, the IDP login page...

Rajneesh · 04-16-2025

Description This article describes the HTTP/HTTPS Proxy used in the ZTNA configuration and what is the difference between them. Scope FortiGate. Solution The attached image displays a simple topology, showing one remote endpoint, FortiGate and the re...

Rajneesh · 12-31-2024

Hello @abdussalam Check this community article it is matching your requirement:https://community.fortinet.com/t5/Support-Forum/Atypical-HA-config-with-two-ISPs/m-p/64587?m=186883

Rajneesh · 12-29-2024

Hello @ULL1903 Following points need to checked: 1. Make sure the device supports the protocols which are running on your existing device. 2. Firewall policies needs to be correctly applied, else it will break the communicationn. 3. Device hardware c...

Rajneesh · 12-25-2024

Hello @iivel Refer to this KB article Technical Tip: Interpreting WSAGetLastError() in FortiClient Debug log:https://community.fortinet.com/t5/FortiClient/Technical-Tip-Interpreting-WSAGetLastError-in-FortiClient-Debug/ta-p/191800

Rajneesh · 12-25-2024

Hello @shiryunaga I would suggest you check this KB article: https://community.fortinet.com/t5/FortiGate/Technical-Tip-Fortinet-Auto-Discovery-VPN-ADVPN/ta-p/195698Download the pdf attachment and it has explained about the Dual Region topology.

Rajneesh · 07-11-2024

Hello @alexpendello , You can disable the SSL VPN web-mode globally, and it will prevent the SSL page to load. Sharing the KB article : https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-disable-SSL-VPN-web-mode-globally/ta-p/272406

User Statistics

User Activity

Technical Tip: External threat feed connector not showing in the firewall policy

Troubleshooting Tip: Unknown status of the interface’s showing in SD-WAN monitor

Technical Tip: Scope of password policy in IPsec tunnels

Technical Tip: SAML IDP Redirect Failures on Remote IPsec VPN Connections

Technical Tip: Understanding what is ZTNA HTTP/HTTPS Proxy

Re: Need to know best/efficient practice to implement HA active-active setup using 2 DIA links and F

Re: SECURITY

Re: SSLVPN tunnel connection failed (Error=-20105) after SSL_get Error 5, WSAGetLastError 2746

Re: SDWAN-ADVPN-BGP in multiple layer network

Re: Curious about Web Portal for SSLVPN

Technical Tip: SSL VPN Monitor shows web connectio...

Re: How to check the SFP status on Secondary Firew...

Technical Tip: Understanding what is ZTNA HTTP/HTT...

Technical Tip: Unable to delete the default SD-WAN...

Technical Tip: BGP router-id selection criteria on...

Re: Fortigate HA over two internal switches (two c...

Re: whitelist specific user IP address from block ...

Re: Extract a list of web filters categories from ...

KCS

User Statistics

User Activity

You are leaving our website