Description This article provides information regarding the limitations
on the fnsysctl command when FIPS-CC mode is enabled on a FortiGate.
Scope FortiGate. Solution When a FortiGate runs in FIPS-CC mode for
security compliance, the FortiOS CLI appl...
Description This article describes how to troubleshoot the error 'An
error occurred when attempting to change this reference (system.xx),
this reference must be handled manually.' while trying to add an
interface to the SD-WAN zone with the Integrate...
Description This article describes how to assign multiple FortiSwitch
ports to the same VLAN in one go on FortiGate. Scope FortiGate,
FortiSwitch. Solution In FortiGate GUI, Go to WiFi & Switch Controller
-> FortiSwitch Ports. Select the first port a...
Description This article describes how to enable a disclaimer page for
users connecting to a specific SSID on a FortiGate. Scope FortiGate.
Solution A disclaimer page is a custom message or policy acknowledgment
page that users must accept before gai...
Description This article provides a step-by-step guide on how to create
a Firewall Policy using a VIP directly from the GUI. Scope FortiGate.
Solution This guide shows an easy way to create a firewall policy using
an existing VIP in the FortiGate GUI...
Can you verify if Forticlient is compatible or try with newer version.
Also try increasing idle timeout following this document:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-SSL-VPN-connection-logout-after-8-hours/ta-p/191322
Hello @nplljw , When both shared and per IP bandwidth configurations are
applied traffic remains low priority unless explicitly overridden. High
priority traffic will be forwarded first. The shared limit applies
globally, while the per IP cap restric...
Hello @HyTronix , Yes, you can create an IP Pool on FortiGate 1 with the
range 192.168.10.200-250 and apply it to the VPN policy that allows
traffic from 192.168.20.0/24 to 192.168.10.0/24. When enabling NAT in
the policy, select the created IP Pool.
