FG 60Ev 7.2.4 I need help with the traffic shaping policy triggering and
the traffic direction. When I created a VoIP traffic shaping policy
based on the traffic direction from the source to the destination, which
includes RTP and SIP services, I exp...
FortiWiFi 60Ev. 7.2.4 3CX PBXExternal SIP trunk RTP and SIP port
forwarding (VIP)RTP UDP 9000-10999SIP TCP/UDP 5060Traffic Shaping
Policy:When I checkdiagnose netlink interface list wan1I see that the
class ID 8 forwarded bytes change during the esta...
FortiSwitch 108EStandalone mode7.2.3 I have created ip-dscp-map with 4
queues (0-3) which follows Cisco 4-Class QoS Strategy Model. In
qos-policy (egress policy) I selected Weighted Round-Robin Scheduling.If
I understand it correctly, the queues in t...
FortiSwitch 108Ev. 7.2.3Standalone mode The following commands are
missing (at least these commands): diagnose switch physical-ports
qos-rates diagnose switch physical-ports qos-stats For the following
command: config switch acl ingress there are no ...
FortiSwitch 108EStandalone modev. 7.2.3I have created a LLDP-MED profile
"Phone-LLDP" with MED TLVs:VLAN 100DSCP 46for Voice and Voice
Signaling.And enabled LLDP on a physical port TX/RX with the
"Phone-LLDP" profile.Packet capture on both ends of th...
This is what I used. I used traffic shaping policies and not firewall
policies as you mentioned. I think that shapers can do dscp matching
only but I am not sure.
That is what I thought too when created a policy in one direction. I
expected the traffic flow was from the server to the client, but now I
see that the FortiGate always (in my case) starts the SIP session with
the packets flowing in the opposite dir...
Hi @gfleming, So, that means that the session determines in what traffic
direction the traffic shaping policy must be triggered, right?In my case
the SIP session opens with the client-to-sever SIP packet, I expected
that the session opens with the pa...
This is my final RTP_3CX (a custom service) configuration that worked
for me. config firewall service custom edit "RTP_3CX" set category
"VoIP, Messaging & Other Applications" set comment "Specific ports for
3CX PBX" set color 7 set udp-portrange 491...
Should I disregard FortiSwitch-7.2.3-Feature-Matrix.pdf and trust only
the admin guide?And what about CLI qos diagnostic? diagnose switch
physical-ports qos-stats list and diagnose switch physical-ports
qos-rates list are listed in that guide which d...
