Technical Tip: Adding IPV6 address under the Exemp...

mhemambika · 10-26-2024

Description This article describes a situation where high encryption 3DES and AES cannot be selected in the IPsec tunnel configuration, along with potential causes for this issue. Scope Applicable to FortiGate versions. Solution Check device compatib...

mhemambika · 10-22-2024

Description This article discusses the possibility of adding IPv6 addresses under exempt sources of the Captive Portal, even though the interface is configured with an IPv6 subnet. Scope FortiGate. Solution There are cases where IPv6 traffic is confi...

mhemambika · 09-23-2024

Description This article describes that it is not possible to connect to FortiGuard Servers with source IP setting as loopback interface private IP and configure central SNAT to public IP. Scope FotiGate. Diagram: In Few topologies like the above whe...

mhemambika · 08-29-2024

Description This article describes how to restrict the explicit web proxy connections to the specific IP. Scope FortiGate. Solution To restrict explicit web proxy connections to the specific IP, it is possible to use the below configuration under web...

mhemambika · 02-07-2024

Hello @yeowkm99 I understand that you are trying to configure the email alerts for FortiGate.Please refer this document which has detail explanation of settings for email alerts.https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-configu...

mhemambika · 02-07-2024

Hi @Randy2 The latest version for Fortigate 60 F is 7.4.3.To upgrade from your current version to latest, you need follow upgrade path from this link.https://docs.fortinet.com/upgrade-toolAlso please go through release notes of which ever firmware ve...

mhemambika · 12-04-2023

Dear Welma, Could you please check below:1)Are you able to ping to FortiGate IP. 2)Are you able to telnet to SSL listening interface on ssl port.3)If so, Please check if there are any restrictions in source address of ssl vpn settings. 4)Also check i...

mhemambika · 12-04-2023

Dear Rezafathi,when you create VLAN interface on the firewall, VLAN interfaces will be becoming your logical interfaces for policy inspection, so in the source interface section of firewall policy, you will need to select the VLAN interfaces in order...

mhemambika · 12-04-2023

Hello Umesh, Port block allocation is also a type of port address translation (PAT). It gives you more control on how many ports to be allocated to each lan IP from which the traffic is received on the firewall and firewall should be NATing. As expla...

User Statistics

User Activity

Troubleshooting Tip: Unable to select high encryption options such as 3DES or AES when configuring the IPsec tunnel

Technical Tip: Adding IPV6 address under the Exempt sources for Captive Portal is not Working

Troubleshooting Tip: A specific case where FortiGuard reachability is not working with source IP setting as loopback interface private IP SNAT to public IP

Technical Tip: How to restrict the explicit web proxy connections to the specific IP

Re: FG100F not sending out alert email

Re: Latest firmware for Fortigate60F

Re: Cannot connect to VPN from other sites.

Re: Source Interface Selection

Re: Port block allocation || Fortigate NAT concept ||

Technical Tip: Adding IPV6 address under the Exemp...

Re: Source Interface Selection

Re: Port block allocation || Fortigate NAT concept...

Troubleshooting Tip: A specific case where FortiGu...

Technical Tip: How to restrict the explicit web pr...

Re: Latest firmware for Fortigate60F

KCS