using Verizon MIFI 4G LTE USB modem U620L to connect to the internet.
using Forticlient ver 5.2.3.0633I use the VPN to connect to Citrix
server using either citrix receiver or RDP. My forticlient VPN is
connecting to a Fortigate 300C and I have no pr...
I am looking to pushout new patch level firmware to my managed WiFi 60C.
I see I can go into each managed devices dashboard and select upgrade.
Is there a way to select the firmware and then select all my 60C units
in one step like when pushing out P...
In the IPSEC monitor it shows all VPN tunnels, in the status column
there are 2 designations " Bring up" which I take as the tunnel is down
and " Bring down" as meaning the tunnel is up. When I see the status as
" Bring up" I take that as a problem w...
I have a Fortigate 300C v4mr3 patch10. I have 68 remote sites using
Fortiwifi 60C and have sitetosite VPN tunnels connecting to the 300C.
The WAN1 on the 300C is a 50meg up and down FIOS connection. The VPN
tunnels are used for the remote sites to co...
I am setting up Fortiwifi 60C v4 MR3 patch 10 units at several
locations. At these sites I am using a public internet connection. I am
setting up a site to site VPN tunnel to corporate office for RDP
connection and scanning to a shared network folder...
Ok so back to my original question, in the status column of the VPN
monitor there is no difference between being Idle or a hard
down(equipment needs to be rebooted, or tech sent to site) both states
will show the same status. Can this be changed. Plu...
I based the statement about the tunnel being idle when the status is "
Bring up" because when I called support a few months ago about my
tunnels keep going down the tech looked at it and told me they are up
just in a idle state. Ok I said and went on...
Thanks for the reply. Setting up the VPN tunnels on the 60C I was unable
to use the Hub and Spoke setup because the 60C sites have dynamic IP
addresses. So I used DYNDNS to create the tunnels.