Dear colleagues, Do someone have working solution for the topology like
this: multiple Cisco routers(dynamic WAN IP) -> IPsec tunnel(aggressive
mode) -> FortiGate(static WAN IP, Dialup user IPsec VPN gateway
aggressive mode) ? I`ve tried some combina...
Hello all. I am facing troubles with my 2x FG-200B (5.2.6) in
active-passive cluster. When traffic load rises, performance decreases
dramatically. During performance decrease, there is 2 processes that
appears(with several copies) most of time in the...
Hi all. I`m new at forum. Can anybody help with issue? I got FortiWifi
40c. Running HQIP test on my device. Instructions say: Instructions:-
Wire the network ports as following for NIC loopback test. [WAN1 -WAN2]
[PORT1 - PORT2] [PORT3 - PORT4] [styl...
After adding static neighbours nothing changes. On cisco router I`ve got
notification after configuring neighbour: % OSPF: Configured Nbr
10.0.100.1 is incompatible with OSPF network type on Tunnel0
I`ve found the solution finally. But now I`m facing a new issue: OSPF
doesn`t bring up. I am using Dial Up user IPsec VPN with aggressive
mode. Also I have cofigured static addresses for tunnel interfaces on
FortiGate and on Cisco router. This config...
Hello. I have been facing this issue too. But solution was find with TAC
help. According to
http://docs.fortinet.com/...1/fortigate-cli-52.pdfthere is route-overlap
option for ipsec phase2. By default, when new client has same source IP
address, IPSe...
