Hello We're going to be setting up a S2S VPN tunnel between our FG 1100E
in our production data center and a Meraki MX firewall at one of our
branch sites for sending backups. The FG is in multi-VDOM mode, with the
WAN connection being in a transpare...
I know this is an old post, but I came across it when troubleshooting
the same issue. The solution for us was to set stpforward to enable on
the ports: config system interface edit "port15" set stpforward enable
next edit "port16" set stpforward enab...
Likely not, I don't think we have a reason for separating out into
different VDOMs. Perhaps we need to take a step back and re-evaluate the
bigger picture. We're going to be moving all of our routing off our old
firewalls onto these, the transparent ...
That's a good question. It was set up like this before I got involved so
I'm not sure. Does this complicate things a lot? What setup would you
recommend?
You are leaving our website
You are leaving our site and we cannot be held responsible for the content of external websites
