Hello All, I have four 221B WAPs in a car dealership garage controlled
by a fortiwifi80CM firmware 5.0.3 and the WAPs are running v5 build 039.
I have many clients that are bunching on one AP and it does not seem to
be load balancing the clients. I h...
I upgraded an 80CM to 5.0.2 and when I attempt to upgrade the firmware
of the attached 221B APs, I get a stack overflow error. Now the disk and
cpu usage are above 90%. What could be using up the disk and cpu so
much?
Hello All, We have a FortiWifi 60C that we have 4 APs connected to but
when we try to add another one, it never shows up in the Managed AP
list. We tried two different WAPs and got the same result. Any ideas?
It' s running 4.3.5
Hello All, I configured two 80C units for VRRP operation but it is not
working. What does the docs mean by portX virtual port? Can this be any
value? Also it made me set the vlanid before i could save the virtual
port. What vlanid should be used? It ...
15 on the 2.4 radio and 5 on the 5Ghz radio. I guess it' s not too much
after all. How many clients can this model handle at once? What logic
does the controller use to put a client on a given WAP? Strongest
signal?
I found the max values document which shows the Managed Wireless Access
Points and Max Number of FortiAP Access Points Supported as 5 for the 60
series. So from that logic, if you have the internal radio turned on,
you can have 4 external WAPs and if...
I ran the first two debug lines and it showed some output but only when
I used the " Bring up" feature in the VPN monitor. When I attempt to
send traffic from one side to another, the log shows nothing. I will try
the sniffer line and see what that d...