Hello, I am running Fortigate 600e appliances in HA mode on the main
branch.I have all my branches connected to the main branch via MPLS. I
am setting up a new Fortigate 30e 3G4G INTL model with one MPLS link and
one 4G sim-card connection which is I...
Hi,Im running 600e appliance in my main branch.All branches connected
with MPLS and doing NAT to the internet from the main branch.Last week I
configured BGP with my ISP and advertised all the local subnets in my
MPLS topology, and so far everything ...
Hi,I'm managing 30 branches, all connected via MPLS and running FGTs as
firewalls.There's a main site with a DC (10.7.7.80).I wanted to
authenticate fortigate administrators via LDAPS and use their AD
accounts for login.However, it is working in some...
Hello guys,I own a 600E appliance if it is relevant.I would like to know
a several things regarding the IPSEC VPN: 1. When running the IPSEC
wizard it does generate rules that allow Remote_Subnet>Local_Subnet and
Local_Subnet>Remote_Subnet.my questio...
Hello,I have to set BGP on my Fortigate 600E appliance with my isp.I
already configured neighbors, AS and advertised routes and everything is
working fine except: There's 1 network in my routing table which is
10.10.0.0/16I have to advertise to my ne...
Did you try defining a Zone of the LAN trusted networks (port 1,2) ? and
apply a policy as: Trusted_Networks > Trusted_Networks / Any / Any / Any
/ AcceptI had this problem once and that was the solution.
Internal traffic, at almost any org, passes through the firewall due to
existence of vlans.When you handle large networks you want to separate
your LAN to different vlans, and traffic between vlans has to pass
through the firewall and match the corre...
if the IPSEC tunnels configured to use "no NAT between sites",On the
branch - did you verify that you have a static route points to the
protected subnets of the site which is tunneled to the HQ appliance from
the other side ?
